Change a Propane Tank
Forklifts fueled by propane are common inside warehouse environments. These forklifts have a propane mount located at the back of the operator. These tanks have to be replaced every so often because they have limited lifespans. Forklift drivers should utilize care when handling propane tanks. Compressed gases are very dangerous, especially since the gas is flammable. Utilize caution when removing and replacing propane tank to prevent being injured.
1 To change a propane tank, first stop the forklift and leave the engine running, and turn the valve on the tank off. Let the forklift run until the engine dies. This process burns the gas off inside the transfer hose that connects the tank and the engine. Prior to taking the next steps, put on the proper safety equipment, like for example insulated gloves made of either leather or neoprene. It is vital for you to protect your skin from touching the compressed gas, that is extremely cold.
2 The hose of the tank has to be disconnected, followed by removing the tank from its holding straps. When putting in a new tank, reconnect the holding straps and reconnect the hose at the valve of the tank by tightening the nut.
3 You could inspect for leaks by applying soapy water to the valve and opening it slightly. Leaking gas will cause bubbles to froth around the value. If this happens, check the connection hose at the nut and the valve area. Re-tighten the connecting nut if you detect any leaks around the valve area, and afterward perform the leak inspection procedure over again. Persistent leaks mean that the nut and connecting hose must be replaced. However, if replacing the hose and nut still does not stop the leak, the tank must be replaced.
4 Open the valve all the way to enable the gas to fill the connecting hose. Then you could start the lift truck and resume working.